IPWorks BLE 2020 Delphi Edition

Questions / Feedback?

BLEClient Errors

BLEClient Errors

600   Invalid UUID.
601   Invalid Id.
602   Action not allowed. See error message for more details.
603   Scanning error. See error message for more details.
604   Connection error. See error message for more details.
605   Must be connected to a device to perform the requested action.
606   Error during communication. See error message for more details.
607   Device unreachable during communication attempt.
608   Error during discovery. See error message for more details.
609   Component detected a cycle of included services.
610   General read error. See error message for more details.
611   General write error. See error message for more details.
612   Application-specific protocol error. This error code indicates that a protocol error code in the range 0x80-0x9F was returned during a BLE communication. Such error codes are reserved for applications to use as they see fit. Refer to the documentation of your remote device for more information.
613   Bluetooth low energy not supported.
701   Invalid Handle: The attribute handle given was not valid on this server.
702   Read Not Permitted: The attribute cannot be read due to its permissions.
703   Write Not Permitted: The attribute cannot be written due to its permissions.
704   Invalid PDU: The attribute PDU was invalid.
705   Insufficient Authentication: The attribute requires authentication before it can be read or written.
706   Request Not Supported: Attribute server does not support the request received from the client.
707   Invalid Offset: Offset specified was past the end of the attribute's value.
708   Insufficient Authorization: The attribute requires authorization before it can be read or written.
709   Prepare Queue Full: Too many prepare writes have been queued.
710   Attribute Not Found: No attribute found within the given attribute handle range.
711   Attribute Not Long: The attribute cannot be read or written using the Read Blob Request.
712   Insufficient Encryption Key Size: The Encryption Key Size used for encrypting this link is insufficient.
713   Invalid Attribute Value Length: The attribute value length is invalid for the operation.
714   Unlikely Error: The attribute request that was requested has encountered an error that was unlikely, and therefore could not be completed as requested.
715   Insufficient Encryption: The attribute requires encryption before it can be read or written.
716   Unsupported Group Type: The attribute type is not a supported grouping attribute as defined by a higher layer specification.
717   Insufficient Resources: Insufficient Resources to complete the request.
952   Write Request Rejected: A requested write operation could not be fulfilled for reasons other than its permissions.
953   Client Characteristic Configuration Descriptor (CCCD) Improperly Configured: The CCCD is not configured according to the requirements of the profile or service.
954   Procedure Already in Progress: A profile or service request cannot be serviced because a previously triggered operation is still in progress.
955   Out of Range: An attribute value is out of range (as defined by a profile or service specification).

Copyright (c) 2022 /n software inc. - All rights reserved.
IPWorks BLE 2020 Delphi Edition - Version 20.0 [Build 8158]